Concrete Finisher – Huntsville, AL, 2951

Location Huntsville, AL
Date Posted August 10, 2018
Category Commercial/Residential
Job Type Seasonal/Temp

Description

Job Description:
Smooth and finish surfaces of poured concrete, such as floors, walks, sidewalks, or curbs using a variety of hand and power tools. Align forms for sidewalks, curbs, or gutters; patch voids; use saws to cut expansion joints. May perform other duties as needed.

Job Tasks:
Check the forms that hold the concrete to see that they are properly constructed.
Set the forms that hold concrete to the desired pitch and depth, and align them.
Spread, level, and smooth concrete, using rake, shovel, hand or power trowel, hand or power screed, and float.
Mold expansion joints and edges, using edging tools, jointers, and straight edge.
Monitor how the wind, heat, or cold affect the curing of the concrete throughout the entire process.
Signal truck driver to position truck to facilitate pouring concrete, and move chute to direct concrete on forms.
Produce rough concrete surface, using broom.
Operate power vibrator to compact concrete.
Direct the casting of the concrete and supervise laborers who use shovels or special tools to spread it.
Mix cement, sand, and water to produce concrete, grout, or slurry, using hoe, trowel, tamper, scraper, or concrete-mixing machine.
Cut out damaged areas, drill holes for reinforcing rods, and position reinforcing rods to repair concrete, using power saw and drill.
Wet concrete surface, and rub with stone to smooth surface and obtain specified finish.
Wet surface to prepare for bonding, fill holes and cracks with grout or slurry, and smooth, using trowel.
Clean chipped area, using wire brush, and feel and observe surface to determine if it is rough or uneven.
Apply hardening and sealing compounds to cure surface of concrete, and waterproof or restore surface.
Chip, scrape, and grind high spots, ridges, and rough projections to finish concrete, using pneumatic chisels, power grinders, or hand tools.
Build wooden molds, and clamp molds around area to be repaired, using hand tools.
Sprinkle colored marble or stone chips, powdered steel, or coloring powder over surface to produce prescribed finish.
Cut metal division strips, and press them into terrazzo base so that top edges form desired design or pattern.
Fabricate concrete beams, columns, and panels.
Waterproof or restore concrete surfaces, using appropriate compounds.
Install anchor bolts, steel plates, door sills and other fixtures in freshly poured concrete.
Apply muriatic acid to clean surface, and rinse with water.
Polish surface, using polishing or surfacing machine.

upload file … Limit reached, delete at least one file above to add more.